49mm Quarter Fairing bracket kit 2006-2017 Dyna

Installation Instructions
49MM Quarter Fairing Bracket Kit

Parts List:

  • Adapter Brackets (2)
  • Quick Release Mechanism (2)
  • 5/16 x 24 Bolts (4)
  • Aluminum Spacer
  • Longer 3/8 Bolt
  • Factory Headlight Riser Block (removed during installation)

Installation Steps:

  1. Position the Adapter Brackets:
  2. Mount the Quick Release Mechanism:
  3. Install the Aluminum Spacer:
  4. Remove the Headlight and Factory Block:
  5. Position the Headlight:
  6. Check Alignment:
  7. Review Pictures:
    • The smaller tab on the adapter bracket should face the headlight.
    • The factory bracket that attaches to the fairing should sit inside the supplied adapter brackets.
    • The lever of the quick release should be facing away from the headlight.
    • Use the 5/16 x 24 bolts (4 total) to bolt the quick release mechanism onto the adapter brackets.
    • Place the aluminum spacer underneath the factory headlight riser block.
    • Secure it using the longer 3/8 bolt. This will raise the headlight approximately 1 inch from its original position.
    • When removing the headlight from the lower tree, you’ll also need to remove the pinch bolt holding the headlight to the factory riser block.
    • The factory riser block is offset drilled, so it needs to be rotated 180 degrees and reinstalled.
    • After rotating the factory block, reinstall it. This will position the headlight further forward and allow it to align with the foam gasket on the quarter fairing.
    • Make sure the headlight is positioned properly to sit against the foam gasket of the fairing, ensuring a tight fit.
    • Refer to the installation pictures on the website for visual guidance.

This should help you properly install the headlight with the new spacer and quick-release mechanism.