Road Glide Riser

These risers are made specifically for the 2013 and earlier and the 2014 to present Road Glide models.  The wider base width of the riser allows installation without modifying the factory trim panel, and a view of your gauges without two uprights cutting through the center of them like a traditional riser or t-bar.  The base of the riser features welded in bungs, and because the two uprights are tied together it helps make them feel very rigid and reduce the possible twist seen on taller traditional risers.  The upper clamp section is the same bolt pattern as the standard HD clamp and has a 1" bore to fit standard HD handlebars.  The risers are drilled to accept internal wire, holes at the top are 1" below the clamping surface.  The bars available with them are bent out of all 1" DOM chrome moly tube and are available in standard or throttle by wire.  

Allow 1-2 weeks for delivery

• Risers Available in a 10, 12, 14 and 16" height measured from the base of the bottom crossbar of the riser to the base of the bar mounting surface
• Bars available have a 3" rise, 2.5" pullback, 31" width (same bend as a CR high MX bar)
• Available with a top clamp or will fit most Factory HD top clamps
• Risers and Bars all drilled for internal wire
• Made in the USA